HEIDENHAIN SW 68894x-03 - Manual (Page 125)

HEIDENHAIN CNC PILOT 640 125
3.1
0
Load monit
o
ri
ng (option)
Using load monitoring during production
During program run, the control monitors the utilization and the total
utilization in each interpolator cycle. In parallel with machining, you can
display a graph of the current utilization values for all monitored axes
of the active zone.
To display the utilization values, select the menu View > Edit load
data—the control opens the "Set load data" form and additionally
displays the determined values as a bar graph
To display the current utilization values, press the Display active zone
soft key—the control automatically switches to the current monitoring
zone and displays the current utilization values as a bar graph
Keep in mind that you cannot adapt the limit values during
machining. Adapt the limit values before starting a
machining operation.
OPEN DIAGRAM DURING MACHINING
Bar graph
Thick upper bar (display in %)
Green
Current utilization (PA)
Mark in thick upper bar:
Green
Current peak value between 0 and limit value 1 (P)
Yellow Current peak value between P and limit value 1 (PG1)
Red Current peak value between PG1 and limit value 2 (PG1)
Thin lower bar (display standardized to reference value 1):
Green
Current total utilization (WA)
Yellow Current total utilization up to limit value (WGF)