HEIDENHAIN SW 68894x-03 - Manual (Page 62)

62 Basics of operation
2.6 The er
ro
r messag
es
2.6 The error messages
Display of errors
The CNC PILOT generates error messages when it detects problems
such as:
 Incorrect data input
 Logical errors in the program
 Contour elements that are impossible to machine
When an error occurs, it is displayed in red type in the header. Long
and multi-line error messages are displayed in abbreviated form. If an
error occurs in a background mode, the error symbol is shown in the
operating mode tab. Complete information on all pending errors is
shown in the error window.
If a rare "processor check error" should occur, the CNC PILOT
automatically opens the error window. You cannot remove such an
error. Shut down the system and restart the CNC PILOT.
The error message is displayed in the header until it is cleared or
replaced by a higher-priority error.
An error message that contains the block number of an NC program
was caused by an error in the indicated block or in the preceding block.
Opening the error window
 Press the ERR key. The CNC PILOT opens the error
window and displays all accumulated error
messages.
Closing the error window
 Press the END soft key—or
 Press the ERR key. The CNC PILOT closes the error
window.