HEIDENHAIN SW 68894x-03 - Manual (Page 406)

406 ICP programming
5.8 Cont
our elements of a t
u
rn
ing cont
our
Thread undercut DIN 76
Select the form elements.
Select Undercut DIN 76.
Enter the undercut parameters.
In smart.Turn, ICP generates a G25.
The CNC PILOT calculates unentered parameters automatically from
the standard table (see “DIN 76—undercut parameters” auf
Seite 615):
 The "thread pitch FP" is determined from the diameter.
 The parameters I, K, W, and R are calculated from the thread pitch
FP.
Parameters
FP
Thread pitch (default: value from standard table)
I Undercut depth (radius) (default: value from standard
table)
K Undercut length (default: value from standard table)
R Undercut radius (default: value from standard table)
W Undercut angle (default: value from standard table)
U, F, D, FP: See machining attributes on Seite 375
 If you are programming an internal thread, it is advisable
to preset the thread pitch FP, since the diameter of the
longitudinal element is not the thread diameter. If you
have the CNC PILOT calculate the thread pitch
automatically, slight deviations may occur.
 Undercuts can be programmed only between two linear
elements. One of the two linear elements must be
parallel to the X axis.