HEIDENHAIN SW 68894x-03 - Manual (Page 470)

470 ICP programming
5.15 Cont
ours in the YZ plane
Rectangle in YZ plane
You can find the reference diameter XR with the "select reference
plane" function (siehe Seite 425).
ICP generates:
 The LATERAL_Y section code with the parameters reference
diameter and spindle angle. The section code is omitted for nested
contours.
 A G308 with the parameters contour name and milling depth.
 A G385 with the parameters of the figure.
 A G309.
Reference data in YZ plane
ID
Contour name
PT Milling depth
C Spindle angle
XR Reference diameter
Parameters of figure
YM, ZM
Figure center
A Position angle (reference: X axis)
K Length
B Width
BR Rounding arc