HEIDENHAIN SW 68894x-03 - Manual (Page 370)

370 Teach-in mode
4.1
0
DIN cy
cles
4.10 DIN cycles
DIN cycle
Select DIN cycle
This function allows you to select a DIN cycle (DIN subprogram) and
integrate it in a cycle program. The dialogs of the parameters defined in
the subprogram are then shown in the form.
The technology data that are programmed in the DIN cycle (in Manual
mode, the currently active technology data) become effective as soon
as you start the DIN subprogram. You can change the machine data
(T, S, F) at any time by editing the DIN subprogram.
Cycle parameters
L
DIN macro number
Q Number of repetitions (default: 1)
LA-LF Transfer values
LH-LK Transfer values
LO-LP Transfer values
LR-LS Transfer values
LU Transfer value
LW-LZ Transfer values
LN Transfer value
T Turret pocket number
ID Tool ID number
S Spindle speed/cutting speed
F Feed per revolution
MT M after T: M function that is executed after the tool call T.
MFS M at beginning: M function that is executed at the
beginning of the machining step.
MFE M at end: M function that is executed at the end of the
machining step.