Grass Valley Prelude v.3.0 - Manual (Page 71)

Prelude — Instruction Manual 71
Prelude Native Protocol Server
Additional Parameter Settings
Besides the name of the client configuration and communications settings
(IP address or serial connection settings), additional parameters can be set
for the client.
Refresh Rate When non-zero, indicates the number of seconds the
client can remain silent. If the client does not send any
command within this duration, the server will declare it
an inactive client, drop all Protects done by it, and dis-
connect the client.
Debug Rx If ON, the server logs every command received by this
client on the console. Leave OFF unless debugging.
Debug Tx If ON, the server will logs every response sent to this
client on the console. Leave OFF unless debugging.
Salvo Lock When ON, prevents Salvo operation.
Protect Override If ON, individual Take commands (NOT Salvos) issued
by a client will go through even if the Destination is Pro-
tected/locked by some other device. This flag should be
turned ON only if absolutely necessary.
Retain Protects When ON, the Protects issued by a client are retained
even after the client disconnects. If the Destinations pro-
tected by this client need to be unprotected, either the
client has to reconnect and issue unprotect commands
or the user needs to unprotect the Destinations from the
control panel hosting the client. When OFF, all the Pro-
tects issued by this client are unprotected as soon as the
client disconnects.
Query Only If ON, Take, Protect, and Salvo commands from this
client are not executed. Only query commands will be
executed.
The Save button at the bottom of the client configuration window saves the
current client configuration under its Client Name. The Cancel button exits