Grass Valley Prelude v.3.0 - Manual (Page 67)

Prelude — Instruction Manual 67
Output Monitoring
Configure Output Monitoring on a Panel
With an output monitor defined, you can now configure a control panel
that supports this feature.
4. Select the tab of a Prelude control panel that supports output
monitoring. This example uses an XY panel.
5. Check the Monitor Control box on the lower right portion of the screen.
This activates the feature and activates the Dst Monitor/Page control.
6. Click on the Dst Monitor/Page button and select the Destination Monitor
defined above, and choose a default Destination ( Figure 54 ). If you
want to use the control panel only for monitoring, checking the
Monitor Only box will prevent that panel from initiating any Takes.
Figure 54. Prelude XY Panel Output Monitor Configuration
Note It is possible to assign an output monitor to more than one panel. In this case,
the last monitor Take from any assigned panel will be honored. There may be
no indication on the panel which Destination is actually being monitored. This
can obviously cause confusion if different operators are controlling the same
output monitoring simultaneously.