Grass Valley Prelude v.3.0 - Manual (Page 65)

Prelude — Instruction Manual 65
Output Monitoring
Output Monitoring
Prelude supports Concerto output monitor control, which permits the
viewing of output signals. This feature is typically used for quality control
purposes. Selecting a Destination on a control panel configured for output
monitoring will route that Destination’s output (showing its current
Source) to an output monitor connector. This displayed signal will track
any Source changes that occur for the currently selected Destination.
The Concerto matrix needs to be properly installed and cabled for output
monitoring. Concerto systems support one output monitor per matrix.
Refer to the Concerto Instruction Manual for specific information about hard-
ware installation and cabling.
Output monitoring is configured in Prelude by adding output monitors to
Concerto Levels, defining an output monitor, and then configuring a
control panel for output monitoring.
Add an Output Monitor
1. Go to the Prelude Levels screen, click on an Output Monitor cell, and type
in the number 1 for each level to be monitored. This adds an output
monitor to the configuration ( Figure 51 ).
Figure 51. Prelude Levels Screen, Output Monitors Added
Note Output Monitor values entered for non-Concerto matrices will revert to 0.