Grass Valley Prelude v.3.0 - Manual (Page 40)

40 Prelude — Instruction Manual
Section 2 — Installation and Initial Setup
12. You can similarly assign Source connectors to the named Sources by
entering the first number in each column then fill the series (
Figure 24 ).
If you divided a board into two levels, the connector numbers for the
added level will typically start with the next higher connector on that
board.
Figure 24. Concerto Source Connectors Filled In
13. In this example the Destination connectors will be like the Sources, so
you can copy and paste the fields. Select all the Source connector fields
for all the levels, then right click and choose
Copy ( Figure 25 ).
Figure 25. Fields Selected for Copy.