Grass Valley Prelude v.3.0 - Manual (Page 30)

30 Prelude — Instruction Manual
Section 2 — Installation and Initial Setup
3. Check the control panel software versions. Navigate to Prelude and click
on Panels . Control panels with Prelude software installed will be listed
on the right with their IP addresses and the version of the Prelude
software will be reported.
Figure 11. Control Panel Software Versions
Current
Software
Versions
Note Other items on this menu are used to convert older Acappella or Encore
control panels for use by Encore. See Panel Conversions
on page 51 ) for
more information.
Update Any Older Software
If any older versions of software were found the devices need to be
updated, using the following procedure.
1. With the latest version of Prelude software and NetConfig installed on
the PC configured for the Prelude network, run NetConfig and click on
the
Load SW toolbar button.
2. Navigate to the frame or control panel as described above ( Figure 9 ,
Figure 10 , and Figure 11 ) and select the check box(s) for the older
device(s).
3. Make sure the Re-Boot when Complete box is checked, then click Load . The
software will be loaded to the device(s) over the network and the
device(s) will be reset.
4. When done, confirm again that the latest software is loaded on all the
Prelude components.