Define a salvo button – Grass Valley Prelude v.3.0 User Manual
Page 57
Prelude — Instruction Manual
57
Salvos
48B, BPS, and Acappella Panel Configuration for Salvos
Define a Salvo Button
This procedure is similar to the standard method of defining button func-
tions for Destinations and Sources described earlier.
1.
Go to the Prelude UI configuration page of the panel type desired by
clicking on its tab.
2.
Either
Load
an existing panel configuration file, or
Get
a configuration
from a panel.
3.
Right click on the
Function
cell of the desired button, select
Set Function
,
then choose
Svo Select
).
Figure 43. Salvo Function Button Selection
4.
Right click on the
Selection
cell for that button and choose the desired
salvo.
CAUTION All defined salvos will be displayed, not just salvos created by for the cur-
rently loaded router configuration. Be sure to choose a compatible salvo.
5.
Repeat
and
for any other buttons you wish to use for a
salvo.
6.
Click
Send Panel Config to Control Panel
, select the appropriate control
panel(s), make sure the
Re-Boot when complete
box is checked, then click
OK
.
7.
Back up the panel configuration file to your PC by clicking on
Save Panel
Config to File
and either overwrite the existing file or give it a new
descriptive name.