Grass Valley Prelude v.3.0 - Manual (Page 28)

28 Prelude — Instruction Manual
Section 2 — Installation and Initial Setup
Prelude Software Compatibility
On newly shipped Prelude systems, the latest software should have been
loaded onto all the components. Software versions for each component
must be compatible for proper operation. The following software compo-
nents have been tested for compatibility
Table 4. Prelude System Compatible Versions
Component Software Version
Prelude
Software
V3.0.0
NetConfig 2.0.10
Concerto Frame 1.7.5.2
Acappella Frame 3.0.0
Acappella Remote Panel Prelude 3.0.0
Encore Control Panel Prelude 3.0.0
Kalypso Control Panel Prelude 3.0.0
Soft Panels 3.0.0
Visual Status Display 1.1.0
Prelude Version 2.0 and 3.0 Backward Compatibility
The router configuration file format has changed in Prelude 3.0 to support
new features. Newer Prelude 3.0 version router configuration files will not
work on systems downgraded back to Prelude 2.0. Though downgrading
to an earlier version of software shouldn’t be necessary, backing up your 2.0
router configuration files before you update to Prelude 3.0 software can be
helpful just in case.
Router configuration files can be backed up by saving the Route_Config
folder under a new name in a secure location (perhaps a removable
memory stick). The folder is located at:
C:\Program Files\Grass Valley Group\
Prelude_Install_Directory\Route_Config
To regain access to the router configuration files after a Prelude 2.0 down-
grade, rename existing folder with that name, copy the backed up folder to
that location and restore its original Route_Config file name.
Check Software Versions
On newly shipped Prelude systems, the latest software should have been
loaded onto all the components. Software versions must be the same for
each device type for proper operation. To check the software versions:
1. Click the NetConfig Load SW toolbar button.