Grass Valley Prelude v.3.0 - Manual (Page 44)

44 Prelude — Instruction Manual
Section 2 — Installation and Initial Setup
Send Router Configuration to All Panels
The router configuration file now needs to be sent to all the control panels
included in your Prelude system.
CAUTION The same router configuration must be sent to all Prelude system control
panels. Identical configurations are required for consistent system operation.
All panels must be connected before the router configuration is sent. If a dis-
connected panel with an old configuration is re-connected, it will send that
old router configuration to the matrices, which could adversely affect Prelude
system operation.
1. Make sure the correct router configuration file is loaded into the
Prelude UI. If necessary, click on the
Load Router Config from File... button,
select the router configuration you saved and click Load .
2. Click on Send Router Config to Control Panel , ensure that all the panels are
connected and selected, make sure the Re-Boot when complete box is
checked, and then click OK ( Figure 31 ). The router configuration file will
be sent to each panel in turn.
Figure 31. Control Panels Selected to Receive Router Configuration File.
Create Panel Configurations
Prelude panels need to know what the router matrix consists of, and then
the specific control capabilities of that panel over that router can be defined.
To accomplish this, the router configuration must first be loaded into the
Prelude UI. This provides information required to configure the panel.
Later the new panel configuration is sent to each control panel.
Note Sample Panel configuration files are included on the software CD. See
Sample Configuration Files
on page 35 .