Grass Valley Prelude v.3.0 - Manual (Page 18)

18 Prelude — Instruction Manual
Section 2 — Installation and Initial Setup
Prelude/Acappella System
Figure 3. Prelude/Acappella System Example
RATED CURRENT: 0.35 A CAMERA JOYSTICK OVERRIDE FREQUENCY: 47-440 Hz RATED VOLTAGE RANGE: 85-260 VAC
LA N
Audio In
Audio In
Audio
Out
Audio
Out
Audio
Out
Audio
Out
Video In
Video In
Video
Out
Video
Out
Video
Out
Video
Out
100BaseT Ethernet
Video/Audio/Reference
Prelude System Cabling - Acappela Frames
Network
Ref
Term
Video
Ref In
Audio In
Acappella
AES Audio
Frame
SW Installation and
Configuration PC
(customer supplied)
(Up to 32 Panels)
Remote Control Panels
Front
Ethernet Switch
(customer supplied)
Rear
Acappella
SD Video
AES Audio Frame
Audio In
Audio
Out
Audio
Out
Audio
Out
Audio
Out
100BaseT Ethernet
Ref Loop
8382_06_r0
(Up to 8 Frames)
Acappella Installation Notes
• Each Acappella matrix frame can be configured with up to four levels,
but multiple Acappella frames cannot be combined into a single matrix.
Combined Concerto/Acappella Prelude System
A Prelude system with both Concerto and Acappella frames can be created,
with the following additional considerations:
• The default IP addresses of Concerto and Acappella frames are not in
the same network, and will need to be changed. See Prelude System
Default IP Addresses
on page 20 .
• Video and digital audio reference signals will need to be looped to all
the matrix frames making up the Prelude system.
• Acappella matrix frames cannot be combined with Concerto frames, or
with other Acappella frames to form a combined matrix.