Grass Valley UniConfi NVISION Series v.2.0 - Manual (Page 82)

72
Switch Point Settings
Setting Switching Parameters
NV8288 and NV8288-Plus Routers
1 Select a control card (for an NV8288 or NV8288-Plus frame).
2 From the ‘Window’ menu, select ‘Switch Point Setup’. The ‘Switch Point Setup’ window
appears. Specify an output range at the bottom of the page and click Read Outputs:
Fig. 8-5: Switch Point Setup Window (NV8288)
This table describes each column in the output list:
Column Description
Output The number assigned to the signal for routing purposes. The number usually
refers to the physical port through which the signal is distributed.
Reclock/bypass Indicates whether the output bypasses re-clocking.
HD/SD Indicates whether the output is a standard definition (SD) or high definition (HD)
video signal.
Ref1/Ref2 Indicates whether the output uses video reference 1 or reference 2 (in dual refer-
ence mode only).