Grass Valley UniConfi NVISION Series v.2.0 - Manual (Page 159)

149
UniConfig
User’s Guide
Because we are defining input devices, we must uncheck both output check boxes and
ignore the other columns labeled ‘Output’. (If the devices we are creating were bidirectional,
we would not ignore the outputs.)
For stereo, the inputs will start at 1 and increment by 1 (because there is one connector for
each stereo input).
Complete the settings in this page and click ‘Next’ at the bottom of the window. The third
and final window appears, in which is displayed a table of the devices that will be created:
The table shows the ports for each of the virtual levels for each device. Note that the AES
level (stereo) increments by 1.
If the proposed result appearing in this window is correct, click ‘Finish’. Otherwise, amend or
cancel your entries.
Perform the same 3-step process for stereo outputs. When you process the second step,
ignore the input columns and assign starting and increment values for the outputs.