Grass Valley UniConfi NVISION Series v.2.0 - Manual (Page 44)

34
Communication
Serial and Ethernet Settings
Serial and Ethernet Settings
Changing UniConfig’s Serial Communication Parameters
1 From the ‘Communications’ menu, click ‘Serial’. This places UniConfig in serial mode.
2 Again from the ‘Communications’ menu, click ‘Setup’. The ‘Serial Communications’ dialog
appears:
From the ‘Comm port’ drop-down list, select the communication port number that matches
the port you are using on the configuration PC running UniConfig.
From the ‘Baud Rate’ drop-down list, select a Baud rate. Select 9600 for a front connection to
EM0374 cards. Select 38400 for a rear DIAG connection to any router’s control card.
3 Click OK to accept the settings or, click Cancel to close the dialog without making any-
changes.