Grass Valley Kalypso Installation Planning Guide - Manual (Page 16)

16 Kalypso Installation Planning Guide
Section 2 — Kalypso Control Surfaces
2-M/E Control Surface
A 2-M/E control surface ( Figure 3 ) is used where space may be limited
(remote trucks), or where simultaneous access to more than 2 M/Es is not
needed (smaller studios or post production).
Figure 3. Kalypso 2-M/E Control Surface
A 2-M/E Kalypso control surface has two M/E control banks, a Menu
panel, and two removable media drives (a CD-ROM in the Menu panel and
a separate USB Zip drive). The Local Aux panel is built into the Main panel.
Though this panel has only two M/E control banks, the banks can be dele-
gated to control any of the M/Es of a 4-M/E Kalypso system.
1-M/E Control Surface
A 1-M/E control surface ( Figure 4 ) is designed to operate in conjunction
with a 4-M/E or 2-M/E Main panel as an accessory workstation. It can be
used for pre- or post-production, and can be used during live production
to permit another operator to assist the TD.
Figure 4. Kalypso 2-M/E Control Surface
A basic 1-M/E control surface has only a 1-M/E Main panel. A Menu panel
can be added to a 1-M/E control surface (either a touch screen model or a
PC running the Kalypso menu application). If so equipped, removable
media drives can be configured with the touch screen or PC for data
0619_08_74_r1
2-M/E Main Panel
Local Aux Panel
Integrated into
2-M/E Main Panel Menu Panel
Zip Drive
0619_08_84_r1 K A LY P S O R E M O T E A U X PA N E L R E M O T E A U X P A N E L
1-M/E Main Panel
Menu Panel
(option)
Remote Aux Panel
(option)
Zip Drive
(customer supplied option)