Grass Valley Kalypso Installation Planning Guide - Manual (Page 10)

10 Kalypso Installation Planning Guide
Section 1 — Introduction
Kalypso Classic System
Table 2. Kalypso Classic General Specifications
Power
Video Processor Frame
Power Supply Power
Consumption
100-125 VAC or 200-250 VAC autorange, 50-60 Hz power factor corrected
700 W (no options), 850 W (typical), 1200 W (maximum)
Main Panel
Power Supply Power
Consumption
100-125 VAC or 200-250 VAC autorange 50-60 Hz power factor corrected
4-M/E: 600 W (typical), 800 W (maximum) 2-M/E: 600 W (maximum)
Local Aux Panel
Power Supply Power
Consumption
100-125 VAC or 200-250 VAC
Usually powered through Main Panel, 50 W if powered externally.
Environmental
Temperature Range
Frame, Local Aux
Panel, Menu Panel Ambient temperature for specifications: 20º to 30º C (68º to 86º F)
Ambient temperature for operation: 0º to 40º C (32º to 104º F)
Main Control Panel
Specification: 20º to 30º C (68º to 86º F)
Operational: 0º to 35º C (32º to 95º F)
Relative Humidity Up to 95% (non-condensing)
Table 3. Kalypso Classic System Specifications
Video Standard - Conforms to SMPTE RP-259M
Serial Digital Video Inputs
Number 16 standard, 64 optional, 80 total (non-looping)
Type of Connectors 75 ohm BNC, (SMPTE 259M)
Nominal Amplitude 800 mV peak-to-peak terminated
Return Loss > 15 dB, 5 MHz to 270 MHz
Channel Coding Conforms to SMPTE RP-259M
Ancillary Data Blanked or passed from A background to M/E outputs (includes reentries)
Input Impedance 75 ohm
Maximum Cable Length Equalized
(Belden 8281 type cable)
225 m (738 ft)
Number of Bits 10
Serial Digital Video Outputs
Number
8 standard video (2 connectors each), or up to 4 video/key pairs of Effects
Send. 4-M/E: An additional 40 standard video (2 connectors each) are
optional (32 standard video for 2-M/E)
Type of Connectors 75 ohm BNC, self terminating (SMPTE 259M)
Amplitude 800 mV peak-to-peak across 75 ohm ± 10% (SMPTE 259M)
Return Loss > 15 dB, 5 MHz to 270 MHz
Rise and Fall Times (between 20%
and 80% amplitude points)
Between 400 picosecond and 1.5 nanosecond across 75 ohm termination
Timing Jitter 0.2 UI (SMPTE RP184-1996 method)
Output Impedance 75 ohm
DC Offset on Output < 50 mV across 75 ohm termination
Number of Bits 10
Number of Connectors per Output 2 BNC connectors per channel
Ancillary Data Included on the A program output of each M/E