Grass Valley Kaleido-X (7RU) v.7.70 - Manual (Page 59)

47
Kaleido-X (7RU)
Hardware Description & Installation Manual
The Output D/EXP IP address is replaced with new lines for the IP addresses of Frame B’s
Output A, B, and C cards.
3 If necessary, change the System name and Frame IP address (which will apply to both
frames once they are in joined in expansion mode).
4 Enter the IP addresses currently used by Frame B’s Output A, B, and C cards.
5 Click Save, and then click Apply settings in the sidebar.
Frame A and Frame B should reboot automatically. If Frame B does not reboot
automatically, perform a hard reboot on Frame B only.
6 Open XAdmin, using what is now the expansion system IP address.
7 Click Status and options.
8 Verify that status information appears for all of the cards on both frames in the
expansion system (see Viewing the Status of an Expansion Frame , on page 69).
Notes
• You may see messages on the monitor wall warning you that KX0 heads
are not assigned. This is normal.
• If one or more cards in a Kaleido-X frame is being upgraded (i.e. if a Live
Update is in progress), then it is not possible to apply any changes made
in XAdmin. If you click Apply settings in the XAdmin sidebar, an error
message will appear. This restriction also occurs during the first 10 to 20
seconds after a card is inserted into or removed from the frame. Wait until
the upgrade has finished, and then click Apply settings again.