Grass Valley Kaleido-X (7RU) v.7.70 - Manual (Page 30)

18
Kaleido-X (7RU) Installation
KXO-Dual Output Cards
The following table lists the purpose of each connector associated with card control.
The pinout for the RS-422 signal on the RJ-45 connector on the output cards’ rear panel,
and the wiring diagram for an appropriate adapters, are shown here:
DVI-D OUT 1 DVI-D OUT 2 DVI DVI digital output (no analog signal on this
connector)
RGBHV OUT 1 RGBHV OUT 2 DE-15S High-resolution analog component output
to feed the monitor wall display
ANALOG OUT 1 L ANALOG OUT 2 L WECO Analog audio output (left channel) to feed
the audio monitoring system
ANALOG OUT 1 R ANALOG OUT 2 R WECO Analog audio output (right channel) to
feed the audio monitoring system
AES OUT 1 AES OUT 2 WECO Digital audio output (AES) to feed the audio
monitoring system
OPTION 1 OPTION 2 RJ-45 (for future use)
Connector label Connector type Function
LTC IN 1 BNC Time code input #1
LTC IN 2 WECO Time code input #2
LTC IN 3 WECO Time code input #3
ETHERNET RJ-45 100 Base-T Ethernet connection
USB USB A Connect a mouse, keyboard, or USB key for software
upgrade or data backup
There are three other USB ports accessible on the front of
the card that serve the same functions.
RS-422 RJ-45 (see note
below) Connect to an RS-422 (SMPTE ST 207, EBU-3245) or
RS-485 device or network
Note: The Kaleido-X’s RS-422 ports have an RJ-45 connector in order to
preserve space on a busy panel. The RS-422 interface specifies a DE-9
connector, so if you are using this interface, you will require a DE-9-to-RJ-45
adapter. Grass Valley supplies two adapter models, correctly wired for this
application: a straight adapter (part no. 1737-3000-102), and a crossover
adapter (part no. 1792-3700-100).
Connector label
Connector
type
Function Head 1 Head 2