Grass Valley Kaleido-X (7RU) v.7.70 - Manual (Page 57)

45
Kaleido-X (7RU)
Hardware Description & Installation Manual
5 Gently but firmly, slide one expansion card into the slot labelled OUTPUT D / EXP of the
Kaleido-X that will be designated Frame A.
6 Set the Frame ID switch on the rear panel to the Frame A position.
7 Gently but firmly, slide the other expansion card into the slot labelled OUTPUT D / EXP
of the Kaleido-X that will be designated Frame B.
8 Set the Frame ID switch on the rear panel to the FRAME B position.
9 Connect the two expansion cards using the expansion cables:
• EXP LINK 1 on Frame A to EXP LINK 1 on Frame B
• EXP LINK 2 on Frame A to EXP LINK 2 on Frame B
10 Power up both frames.
Note: Be careful to install the KXO-EXP-R rear panel in the matching
location at the rear of the frame. The KXO-EXP-F card and its rear panel can
be installed in any order. See
Card Installation and Replacement on page 14
for more information.
IMPORTANT
Make sure that there is a KXO card in Slot C of Frame A.
This card will act as the master for the expansion frame. Another output card
may become the master.
Frame ID switch
Connect EXP LINK 1 on FRAME A
to EXP LINK 1 on FRAME B
Connect EXP LINK 2 on FRAME B
to EXP LINK 2 on FRAME A