Grass Valley Kaleido-X (7RU) v.7.70 - Manual (Page 41)

29
Kaleido-X (7RU)
Hardware Description & Installation Manual
Front Card-Edge Indicators
The following LED status indicators are visible on the front edge of the input cards (listed
from top to bottom):
Front Card-Edge Controls
One button is located on the front card edge:
Front Card-Edge Connector
An ICAT connector is located on the front card edge at the bottom below the RESET button.
This connector is reserved for factory use, and has no user functionality.
KXO-24Router Card
The KXO-24Router card provides 24 external monitoring outputs that can be assigned to
any of the 96 HD/SD SDI inputs of the Kaleido-X. Two cards can be installed in a Kaleido-X to
provide up to 48 outputs. These unprocessed outputs can be used to feed high-quality CRT
monitors, test equipment such as waveform monitors, as well as master control or
production switchers.
LED label LED color Interpretation
Card Status Green
Red
Orange
Blinking Red Card OK
Error
Programming in progress
Upgrade in progress
SDTI Status Green
Red Valid signal present
No signal or invalid signal
IN 1 Status to
IN 16 Status
Green
Red Valid signal present
No signal or invalid signal
Button label Function
Reset Reset the FPGA and restart the card (for maintenance use)