Grass Valley iRouter v.6.01 - Manual (Page 54)

Routing Switchers Tips and Tricks
How to display debug window when launching SE Utilities
50
How to display debug window when launching SE Utilities
If you hold down the CTRL key when you launch SE-Utilities it will also launch a console
window. That console window will show debugging output from the application, and it will
most likely tell us exactly what is failing.
How to install SE Utilities on PC
Double-click the SEUtilitiesVx.x.xInstaller.exe file.
How to upgrade NV9000 / NV915 software
Copy the NVSETUP directory on NV9000/NV915 and then double-click NV9000Setup.exe .
NVISION Ethernet Protocol - Enterprise Router (Logical)
NVISION Enterprise routers use TCP/IP to communicate with external devices. The port must
be 9193. You also need to specify the NVISION controller's host name or IP address when
configuring it in Router Manager. After you have created the router and levels with the
appropriate dimension and saved configuration, physical levels will be updated automatically
for you.
Also, in order to fetch labels, take crosspoints or connect free source, NVISION Enterprise
routers will use virtual device id for levels, destinations or sources.
SE Utilities Configuration Hints
To determine the physical Level or frame ID value to set in Router Manager Configurator, from
NV9000 SEUtilities, go to View | Virtual Levels and select the appropriate ID. In order word,
level or frame id = column id in table Virtual levels in SE-utilities
The size is variable, and it can change each time you read mnemonics from the system. You
would need to query the database to obtain the number of sources or destinations in advance
of reading them all using 0x3022.
In order to set the right level size, save your config, open putty to your app server, enable
debug for
com.miranda.icontrol.routers.nv9000virtual.NV9000Virtual to debug in
log4j and restart the iControl Router service. Then open log file router.log and use the grep
command for string source size and destination size.
Troubleshooting
If you cannot connect to an NV9000 controller, try the following command:
telnet IP_ADDRESS_OF_THE_CONTROLLER 9193
If you get a connect failed message, it means that the NV9000 is not properly configured for
remote control.
Configuring NV9000 Routers with Tielines
Steps to perform in SE-Utilities
1. Open SEUtilities (see page 46 ).
Note: To determine the physical Level matching this virtual level, from NV9000
SEUtilities, go to Views -> Level Set Details.