Grass Valley iRouter v.6.01 - Manual (Page 39)

iControl Router
User Guide
35
5. You can also switch crosspoints, by typing x l , and then pressing
Enter twice.
You will get a confirmation like this:
Leitch
The software supports the Leitch ASCII Passthrough protocol. The application server can be
connected to the Leitch system either directly or via an SPT (Serial Protocol Translator). The
serial port on the SPT can be configured to act either as a RS-232 or RS-422 port using jumpers
located under the cover of the box (see the manufacturer’s manual). When using the 232
ports, it is necessary to use a null-modem cable. DIP switches located under the cover of SPT
can be used to configure the baud rate. The other parameters are 8 bits, no parity, 1 stop bit,
and no flow control. Some old versions of the SPT had a bug in the firmware that prevented