Grass Valley iRouter v.6.01 - Manual (Page 12)

Operating Interface
Single Bus Window Common Tasks
8
Select which levels are switched 1. In the Levels area, enable the buttons corresponding to all the levels for which
you would like to enable switching.
2. The current source at the output for each level is shown in the Status column.
Select one or more groups of
destinations 1. In the Destination area, click the Down arrow next to the list of destinations.
The Destination/Group Selection window appears.
2. If you would like to select a single destination, click the desired destination.
3. If you would like to select multiple destinations, click Select group, then either
select the desired destinations by clicking on each of them or click Select group
to select all of them. 2
4. Click OK.
(Continued)
To do this... ...do this...