Troubleshooting, How to, How to start se utilities – Grass Valley iRouter v.6.01 User Manual
Page 50

Routing Switchers Tips and Tricks
Troubleshooting
46
• Jupiter ESSwitch
• Encore Router
• Sierra Video
• Stagetec Nexus
Troubleshooting
There is a known issue with TCP/IP in iControl Router Standalone version 1.70. If you see a lot
of exceptions in the console of the router service, please contact Miranda Technical Support.
You may have to upgrade your iControl Router Standalone installation. The problem has been
seen when running iControl Router Standalone version 1.70 on a K2.
If you cannot connect to an NV9000 controller, try the following command:
telnet IP_ADDRESS_OF_THE_CONTROLLER 9193
If you get a
connect failed
message, it means that the NV9000 is not properly configured for
remote control.
How To...
How to start SE Utilities
1. Connect to NV9000 either directly or via Remote Desktop.
User name:
EnvyAdmin
Password:
software
.
2. On your desktop, double-click on the NV9000-SE Utilities icon.
How to create a physical router in SE Utilities to control a KX router
).
2. On the Configuration menu, point to Router and click Add Router.
3. Set the router name.
4. Set Router Host to NVCONFIG (default value).
5. Set protocol to NV Ethernet.
6. Set Primary Control Point to the KX IP address (for example,
10.6.6.50).
7. Leave Secondary Control Point blank.
8. Click Add to add Physical Level.
9. Set digit under # to match Physical level of KX router in XEdit (normally this would be 0).
10. Set Input Start, Input End, Output Start, Output End to match dimension of KX router.
Input Start must be set to 1, Output start must be set to 1.
11. Click Save.
12. Go to System Management and select NV9000 node in left pane.
13. Click Write Configuration to NV9000 to send config to NV9000.
14. Click Restart Controller 1.