Grass Valley GV STRATUS Installation v.3.1 - Manual (Page 62)

• SiteConfig has communication with the device.
• The device is defined in the system description with an appropriate network interface.
Use this task to modify managed the control network interface on a GV STRATUS Client PC:
1. In the Interfaces list view determine the interface to configure, as follows:
• Identify the interface with which SiteConfig is currently communicating, indicated by the
green star overlay icon. This should be the control network interface.
• Verify that the interface over which SiteConfig is currently communicating is in fact the
interface defined for the control network in the system description. If this is not the case, you
might have the control network cable connected to the wrong interface port. The control
connection should always be the first port on the motherboard, except when you have a
loopback connection.
• Configure the control network interface first before configuring any of the other interfaces.
• A device can have multiple network interfaces that are not connected and are not required
for system functionality. Give these interfaces a name such as "Unused" to aid identification.
2. In the Interfaces list view, check the icon for the interface you are configuring.
If the icon has a red stop sign overlay, it indicates that current settings and planned settings do
not match or that there is some other problem. Hover over the icon to read a tooltip with
information about the problem.
62 GV STRATUS Installation and Service Manual 2013 12 19
Commissioning a system