Grass Valley HD Wireless - Manual (Page 61)

HD Wireless User’s Guide (v6.2) 61
Chapter 5 - Menu contents
5.2.7 WCU Diagnostics menu
Menu item Values Description Level File
Board ID
Data Board [ID] Displays board 12nc, date, S/N ... Oper -
AudioIcom Board [ID] Displays board 12nc, date, S/N ... Oper -
TriaxRack Board [ID] Displays board 12nc, date, S/N ... Oper -
GenLock Board [ID] Displays board 12nc, date, S/N ... Oper -
Firmware Status
AudioIcom [value] Displays firmware status (not board status) Oper
Genlock [value] Displays firmware status (not board status) Oper
Genlock GX [value] Displays firmware status (not board status) Oper
TriaxRack [value] Displays firmware status (not board status) Oper
AMU 1 [value] Displays firmware status (not board status) Oper
AMU 2 [value] Displays firmware status (not board status) Oper
Board Diagnostics
Data Board Oper -
GenLock Board [value] Install -
Video QOS 0..4 4: optimal signal quality, 0:close to video
breakdown. This figure is also the number
of arrows (>) displayed in the VF. Install -
Data QOS 0..127 Values above 90 are excellent conditions.
Below 80, the bottom green LED inside the
VF starts blinking. This indicator is not
affected by Received Power but will help to
detect same or adjacent channel interferer
(C/I Typical value : ~12 dB @ 0kHz, ~0 dB
@±50 kHz, <-40 dB@±100 kHz) Install -
AMU Diagnostics Install
AutoRange 2.0-2.2 | 2.2-2.4 | 2.4-2.5 |
2.5-2.7 | 2.7-2.9 Detected Frequency Range Install
AMU 1(2) Ok, Incomplete,
Inconsistent, Not
connected OK : 3 DCs of same Frequency range are
connected
Incomplete : LESS than3 DCs of same
Frequency range are connected
Inconsistent : 3 DCs are connected BUT
NOT of same Frequency range
Not connected : There is no AMU
connected on that triax input
AMU 1(2) DCs menu allows to refine the
diagnostics (see below) Install
AMU 1(2) DCs
AMU 1(2) DC1 unknown | 2.0-2.2 | 2.2-2.4
| 2.4-2.5 | 2.5-2.7 | 2.7-2.9 Detected frequency range of down-
converter 3 of AMU 1(2)
Disconnected DC will be reported as
unknown. Install