Grass Valley HD Wireless User Manual
Page 50
50
HD Wireless User’s Guide (v6.2)
Chapter 4 - Setting up
PC OK
When a remote PC is connected to the front plug of the WCU Audio Board, this LED lights
to indicate the status of the connection. When no PC is connected, it lights to indicate an
internal fault.
:
TRIAX 1 SELECTED
Reflects the status of roaming (AMU1/AMU2) and AMU under control of WCU.
TRIAX 1 OK
Reflects the status of the Triax link (AMU -> WCU) and checks for video content.
PC OK (Green)
PC connected
Message
Off
No
Internal switch configuration is OK.
Flashing
No
Internal switch configuration is not OK.
On
Yes
PC <> WCU dialog is running
Triax Sel. (Orange)
Message
On
This triax input is selected by the roaming.
Flashing (~5/s)
AMU is not acknowledging control data sent by WCU.
Off
AMU is not connected, or not selected by roaming.
Triax OK. (Green)
Message
On
Triax link (AMU -> WCU) is OK, video content delivered by AMU is OK.
Flashing (~1/s)
Triax link (AMU -> WCU) is OK, no video content delivered by AMU.
Off
Triax link (AMU -> WCU) is not OK or AMU is not connected.
Triax Sel. (Orange)
Triax OK (Green)
Message
On
On
Triax input is selected. Video transmission in Triax is
OK.
Off
On
Triax input is not selected. Video transmission in Triax
is OK.
Flashing (~5/s)
-
AMU is not acknowledging control data sent by
WCU. Check Triax or AMU’s internal coax cable to
Triax.
Triax 1 and Triax2 Sel.
both flashing (~5/s)
Triax 1 and Triax2 Sel.
both flashing (~5/s)
The down-converts connected to the AMU(s) are not
suited for the same frequency range. Note:
disconnected down-converters are not reported even
if the other connected converters are coherent.
-
Flashing (~1/s)
Triax link (AMU -> WCU) is OK, no video content
delivered by AMU.
On
Off
Video transmission in Triax is not OK.