Grass Valley HD Wireless - Manual (Page 47)

HD Wireless User’s Guide (v6.2) 47
Chapter 4 - Setting up
4.4 Wireless Control Unit (WCU)
4.4.1 Select a video scanning mode
The video mode for the camera is set in the WCU System menu. The mode set here overrides
the mode set in the camera when a connection is established.
Menu path: SYSTEM > VIDEOMODE
☞
Note
The video mode menu item is only shown when there is no connection with the camera.
However, scanning mode can also be controlled by OCP 400.
4.4.2 Set transmission frequencies
1. Select video transmission frequency in steps of 1 MHz.


Menu path: SYSTEM
> WIRELESS > VIDEO FREQUENCY
2. Select data transmission frequency in steps of 50 kHz.


Menu path: SYSTEM
> WIRELESS > DATA FREQUENCY
☞
Note
The frequencies selected must be the same as those selected in the camera.
4.4.3 Set transmission profiles
In the WCU System menu, set the same transmission parameters that you selected for the
three profiles in the camera:
Menu path: SYSTEM > WIRELESS > RX PARAM > IN_OUTDOOR
Menu path: SYSTEM > WIRELESS > RX PARAM > Q_ROBUST
Menu path: SYSTEM > WIRELESS > RX PARAM > Q_LATENCY
☞
Note
The selected IN_OUTDOOR and Q_ROBUST parameters must be the same as those selected
in the camera head. When you change Q_LATENCY in the WCU the WCA is automatically
updated.
4.4.4 Select camera number
The camera number selected must be the same as that selected in the camera. In the System
menu go to the Camera number submenu where you can select the number.
Menu path: SYSTEM > CAMERA NUMBER