Grass Valley HD Wireless - Manual (Page 44)

44 HD Wireless User’s Guide (v6.2)
Chapter 4 - Setting up
If CAM MIC is set to PROD in the install menu it overrides other assigned routing
switches (whatever their state is) and switches off the downlink intercom to PROD;
Intercom headset socket
Connect the intercom headset to this XLR-5 socket.
Camera intercom menu
The Intercom section of the Install menu contains various settings for the intercom channels.
Intercom microphone amplification levels, phantom power supply and microphone on/off
switches are also available in this menu.
Intercom microphone routing
Assignable buttons on the camera can also be set to select either ENG or PROD. These
buttons override the Intercom Microphone switch on the back of the WCA.
4.2.7 Viewfinder indications
Check QoS LED (data)
1. In the camera viewfinder check the ! indicator that indicates the Quality of Service (QoS)
of the data signal: Off is OK, flashing is critical.
Select cell number for display
1. In a dual AMU system it can be useful to see which AMU is being used by the camera.
The cell number of the AMU currently in use can be displayed in the bottom right corner of
the viewfinder.
2. The display of the cell number in the viewfinder is selected in the camera menu. In the
camera system menu, go to the Box DownRight item and select CELL.
Menu path: VF > BOX DOWNRIGHT