beautypg.com

2 wireless camera adapter (wca), 1 attaching an adapter – Grass Valley HD Wireless User Manual

Page 21

background image

HD Wireless User’s Guide (v6.2)

21

Chapter 2 - Installation

2.2 Wireless camera adapter (WCA)

If you decide to change frequency bands, then refer to the Appendix - Exchanging the
frequency module.

Carry out the following steps to prepare the camera for use:

Attach the adapter to the camera.

Attach the antennas to the adapter.

Power the camera via the adapter.

2.2.1 Attaching an adapter

Caution

Be extremely careful with the connectors between the camera head and the adapter. Do not
allow the guide pins to damage the pins of the connector.

Follow these steps in the order given. Tightening or loosening the screws in the wrong order
could result in mechanical damage to the camera.

To attach an adapter to the camera proceed as follow:

1.

Fit the guide pin at the top rear of the camera head and the guide pins on either side of
the camera connector into the corresponding slots

and

of the adapter.

2.

First, tighten the two horizontal screws

on the top of camera.

3.

Next, tighten the two horizontal screws

at the front of the camera.

4.

Lastly, tighten the vertical screw

in the handle of the camera.

To detach an adapter from the camera head follow the steps for attaching it in the reverse
order.

Figure 2-2. Attaching the adapter

5

1

4

3

2