H3C Technologies H3C S6300 Series Switches - Manual (Page 54)

39
Configuring the IP address of the LDAP server
Step Command Remarks
1. Enter system view. System-view N/A
2. Enter LDAP server view. ldap server server-name N/A
3. Configure the IP address of
the LDAP server. { ip ip-address | ipv6
ipv6-address } [ port port-number ]
By default, an LDAP server has no
IP address.
You can configure either an IPv4
address or an IPv6 address for an
LDAP server. The most recent
configuration takes effect.
Specifying the LDAP version
Specify the LDAP version on the NAS. The device supports LDAPv2 and LDAPv3. The LDAP version
specified on the device must be consistent with the version specified on the LDAP server.
To specify the LDAP version:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter LDAP server view. ldap server server-name N/A
3. Specify the LDAP version. protocol-version { v2 | v3 }
By default, LDAPv3 is used.
A Microsoft LDAP server supports only
LDAPv3.
Setting the LDAP server timeout period
If the device sends a bind or search request to an LDAP server without receiving the server's response
within the server timeout period, the authentication or authorization request times out. Then, the device
tries the backup authentication or authorization method. If no backup method is configured in the ISP
domain, the device considers the authentication or authorization attempt a failure.
To set the LDAP server timeout period:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter LDAP server view. ldap server server-name N/A
3. Set the LDAP server timeout
period.
server-timeout time-interval
By default, the LDAP server timeout
period is 10 seconds.
Configuring administrator attributes
To configure the administrator DN and password for binding with the LDAP server during LDAP
authentication:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter LDAP server view. ldap server server-name N/A