Own in, Figure 56 – H3C Technologies H3C S6300 Series Switches User Manual
Page 150
135
Figure 56 Device list
b.
Click Add to enter the page shown in
Figure 57 Port group configuration
c.
Enter the port group name.
d.
Select the configured IP address group.
The IP address used by the user to access the network must be within this IP address group.
e.
User default values for other parameters.
f.
Click OK.
5.
Select Access Service > Service Parameters > Validate System Configuration from the navigation
tree to validate the configurations.
Configuring the portal authentication server on IMC PLAT 5.0
This example assumes that the portal server runs on IMC PLAT 5.0(E0101) and IMC UAM 5.0(E0101).
1.
Configure the portal authentication server:
a.
Log in to IMC and click the Service tab.
b.
Select User Access Manager > Portal Service Management > Server from the navigation tree to
enter the portal server configuration page, as shown in
c.
Configure the portal server heartbeat interval and user heartbeat interval.
d.
Use the default settings for other parameters.
e.
Click OK.