Verifying the configuration – H3C Technologies H3C S6300 Series Switches User Manual
Page 136
121
[SwitchA–Vlan-interface4] quit
On Switch B, configure a default route to subnet 192.168.0.0/24, specifying the next hop address as
20.20.20.1. (Details not shown.)
Verifying the configuration
Verify that the portal configuration has taken effect.
[SwitchA] display portal interface vlan-interface 4
Portal information of Vlan-interface4
IPv4:
Portal status: Enabled
Authentication type: Layer3
Portal Web server: newpt
Authentication domain: Not configured
Bas-ip: 20.20.20.1
User Detection: Not configured
Action for server detection:
Server type Server name Action
-- -- --
Layer3 source network:
IP address Mask
Destination authenticate subnet:
IP address Mask
IPv6:
Portal status: Disabled
Authentication type: Disabled
Portal Web server: Not configured
Authentication domain: Not configured
Bas-ipv6: Not configured
User detection: Not configured
Action for server detection:
Server type Server name Action
-- -- --
Layer3 source network:
IP address Prefix length
Destination authenticate subnet:
IP address Prefix length
A user can perform portal authentication by using the H3C iNode client or through Web page. Before
passing the authentication, the user can access only the authentication page
http://192.168.0.111:8080/portal and all Web requests will be redirected to the authentication page.
After passing the authentication, the user can access Internet resources.
After the user passes authentication, you can use the following command to display information about
the portal user.
[SwitchA] display portal user interface vlan-interface 4
Total portal users: 1
Username: abc
Portal server: newpt