H3C Technologies H3C S6300 Series Switches - Manual (Page 286)

271
The device that acts as an SSH server does not support SFTP connections initiated by SSH1 clients.
To enable the SFTP server:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable the SFTP server. sftp server enable
By default, the SFTP server is
disabled.
Configuring NETCONF over SSH
After you enable NETCONF over SSH on the device, a client can perform NETCONF operations on the
device through a NETCONF-over-SSH connection.
When the device acts as a server in the NETCONF-over-SSH connection, connection requests initiated by
SSH1 clients are not supported.
For more information about NETCONF over SSH commands, see Network Management and
Monitoring Command Reference.
To configure NETCONF over SSH:
Step Command Remark
1. Enter system view. system-view N/A
2. Enable NETCONF over
SSH.
netconf ssh server enable
By default, NETCONF over SSH is
disabled.
3. Specify a port to listen for
NETCONF-over-SSH
connections.
netconf ssh server port port-number
By default, port 830 listens for
NETCONF-over-SSH connections.
Configuring the user lines for SSH login
Depending on the SSH application, an SSH client can be an Stelnet, SFTP, SCP, or NETCONF-over-SSH
client.
Only Stelnet and NETCONF-over-SSH clients require the user line configuration. The user line
configuration takes effect on the clients at the next login.
To configure the user lines for Stelnet and NETCONF-over-SSH clients:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter VTY user line view. line vty number [ ending-number ] N/A
3. Set the login authentication
mode to scheme.
authentication-mode scheme
By default, the authentication
mode is password.
For more information about this
command, see Fundamentals
Command Reference.