H3C Technologies H3C S6300 Series Switches - Manual (Page 126)

111
5. Select Access Service > Service Parameters > Validate System Configuration from the navigation
tree to validate the configurations.
Configuring the portal authentication server on IMC PLAT 5.0
This example assumes that the portal server runs on IMC PLAT 5.0(E0101) and IMC UAM 5.0(E0101).
1. Configure the portal authentication server:
a. Log in to IMC and click the Service tab.
b. Select User Access Manager > Portal Service Management > Server from the navigation tree to
enter the portal server configuration page, as shown in
Figure 42 .
c. Configure the portal server parameters as needed.
This example uses the default settings.
d. Click OK.
Figure 42 Portal server configuration
2. Configure the IP address group:
a. Select User Access Manager > Portal Service Management > IP Group from the navigation tree
to enter the portal IP address group configuration page.
b. Click Add to enter the page shown in Figure 43 .
c. Enter the IP group name.
d. Enter the start IP address and end IP address of the IP group.
Make sure the host IP address is in the IP group.
e. Select a service group.
This example uses the default group Ungrouped.
f. Select Normal from the Action list.
g. Click OK.