H3C Technologies H3C S6300 Series Switches - Manual (Page 272)

257
Step Command Remarks
2. Enable sending IKE DPD
messages.
ike dpd interval interval-seconds
[ retry seconds ] { on-demand |
periodic }
By default, IKE DPD is disabled.
Enabling invalid SPI recovery
An IPsec "black hole" occurs when one IPsec peer fails (for example, a peer can fail if a reboot occurs).
One peer fails and loses its SAs with the other peer. When an IPsec peer receives a data packet for which
it cannot find an SA, an invalid SPI is encountered. The peer drops the data packet and tries to send an
SPI invalid notification to the data originator. This notification is sent by using the IKE SA. Because no IKE
SA is available, the notification is not sent. The originating peer continues sending the data by using the
IPsec SA that has the invalid SPI, and the receiving peer keeps dropping the traffic.
The invalid SPI recovery feature enables the receiving peer to set up an IKE SA with the originator so that
an SPI invalid notification can be sent. Upon receiving the notification, the originating peer deletes the
IPsec SA that has the invalid SPI. If the originator has data to send, new SAs will be set up.
Use caution when you enable the invalid SPI recovery feature because using this feature can result in a
DoS attack. Attackers can make a great number of invalid SPI notifications to the same peer.
To enable invalid SPI recovery:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable invalid SPI recovery. ike invalid-spi-recovery enable
By default, the invalid SPI recovery
is disabled.
Setting the maximum number of IKE SAs
You can set the maximum number of half-open IKE SAs and the maximum number of established IKE SAs.
• The supported maximum number of half-open IKE SAs depends on the device's processing
capability. Adjust the maximum number of half-open IKE SAs to make full use of the device's
processing capability without affecting the IKE SA negotiation efficiency.
• The supported maximum number of established IKE SAs depends on the device's memory space.
Adjust the maximum number of established IKE SAs to make full use of the device's memory space
without affecting other applications in the system.
To set the limit on the number of IKE SAs:
Step Command Remarks
1. Enter system view. system-view N/A
2. Set the maximum number of
half-open IKE SAs and the
maximum number of
established IKE SAs.
ike limit { max-negotiating-sa
negotiation-limit | max-sa
sa-limit }
By default, there is no limit to the
maximum number of IKE SAs.