H3C Technologies H3C S10500 Series Switches - Manual (Page 72)

63
To do… Use the command… Remarks
Specify the current device as the
master node of the ring, and
specify the primary port and the
secondary port
ring ring-id node-mode master
[ primary-port interface-type
interface-number ] [ secondary-port
interface-type interface-number ]
level level-value
Required
Specifying a transit node
Perform this configuration on a device to be configured as a transit node.
Follow these steps to specify a transit node:
To do… Use the command… Remarks
Enter system view system-view —
Enter RRPP domain view rrpp domain domain-id —
Specify the current device as a
transit node of the ring, and
specify the primary port and the
secondary port
ring ring-id node-mode transit
[ primary-port interface-type
interface-number ] [ secondary-port
interface-type interface-number ]
level level-value
Required
Specifying an edge node
When configuring an edge node, you must first configure the primary ring before configuring the
subrings.
Perform this configuration on a device to be configured as an edge node.
Follow these steps to specify an edge node:
To do… Use the command… Remarks
Enter system view system-view —
Enter RRPP domain view rrpp domain domain-id —
Specify the current device as a
transit node of the primary ring,
and specify the primary port and
the secondary port
ring ring-id node-mode transit
[ primary-port interface-type
interface-number ] [ secondary-port
interface-type interface-number ]
level level-value
Required
Specify the current device as the
edge node of a subring, and
specify the edge port
ring ring-id node-mode edge
[ edge-port interface-type
interface-number ]
Required
Specifying an assistant-edge node
When configuring an assistant-edge node, you must first configure the primary ring before configuring
the subrings.
Perform this configuration on a device to be configured as an assistant-edge node.
Follow these steps to specify an assistant-edge node:
To do… Use the command… Remarks
Enter system view system-view —