H3C Technologies H3C S10500 Series Switches - Manual (Page 16)

7
CAUTION:
•
The original active MPU will be restarted if an active MPU and standby MPU switchover is performed.
Therefore, ensure the consistency of the software version of the active MPU and standby MPU before
performing active MPU and standby MPU switchover; if their software version is not consistent, you need
to configure to ignore version check of the standby MPU first.
• The switch does not support the slave switchover command when operating in IRF mode.
Displaying and maintaining active and standby
switchover
To do… Use the command… Remarks
Display the switchover state of the
specified MPU (in standalone
mode)
display switchover state [ slot slot-number ] [ |
{ begin | exclude | include }
regular-expression ]
Display the switchover state of the
specified MPU (in IRF mode)
display switchover state [ chassis
chassis-number slot
slot-number ] [ | { begin | exclude | include }
regular-expression ]
Available in any view