High availability overview, Availability requirements, Availability evaluation – H3C Technologies H3C S10500 Series Switches User Manual
Page 10: Mtbf, Mttr
1
High availability overview
Communication interruptions can seriously affect widely-deployed value-added services such as IPTV
and video conference. Therefore, the basic network infrastructures must be able to provide high
availability.
The following are the effective ways to improve availability:
•
Increasing fault tolerance
•
Speeding up fault recovery
•
Reducing impact of faults on services
Availability requirements
Availability requirements fall into three levels based on purpose and implementation, as shown in
Table 1 Availability requirements
Level Requirement
Solution
1
Decrease system software and
hardware faults
•
Hardware: Simplifying circuit design, enhancing
production techniques, and performing reliability tests.
•
Software: Reliability design and test
2
Protect system functions from being
affected if faults occur
Device and link redundancy and deployment of switchover
strategies
3
Enable the system to recover as fast
as possible
Performing fault detection, diagnosis, isolation, and
recovery technologies
The level 1 availability requirement should be considered during the design and production process of
network devices. Level 2 should be considered during network design. Level 3 should be considered
during network deployment, according to the network infrastructure and service characteristics.
Availability evaluation
Mean Time Between Failures (MTBF) and Mean Time to Repair (MTTR) are used to evaluate the
availability of a network.
MTBF
MTBF is the predicted elapsed time between inherent failures of a system during operation. It is typically
in the unit of hours. A higher MTBF means a high availability.
MTTR
MTTR is the average time required to repair a failed system. MTTR in a broad sense also involves spare
parts management and customer services.
MTTR = fault detection time + hardware replacement time + system initialization time + link recovery time
+ routing time + forwarding recovery time. A smaller value of each item means a smaller MTTR and a
higher availability.
- H3C S5800 Series Switches H3C S5820X Series Switches H3C WX3000E Series Wireless Switches H3C SecPath F1000-E H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS