H3C Technologies H3C S10500 Series Switches - Manual (Page 32)

23
Follow these steps to configure a MEP:
To do... Use the command... Remarks
Enter system view system-view —
Configure a MEP list
cfd meplist mep-list
service-instance instance-id
Required
By default, no MEP list is
configured.
Enter Layer 2 Ethernet interface
view
interface interface-type
interface-number
—
Create a MEP
cfd mep mep-id service-instance
instance-id { inbound | outbound } Required
Not configured by default.
Enable the MEP
cfd mep service-instance
instance-id mep mep-id enable Required
Disabled by default.
CAUTION:
You cannot create a MEP if the MEP ID is not included in the MEP list of the service instance.
Configuring MIP generation rules
As functional entities in a service instance, MIPs respond to various CFD frames, such as LTM frames, LBM
frames, 1DM frames, DMM frames, and TST frames.
MIPs are generated on each port automatically according to related MIP generation rules. If a port has
no MIP, the system will check the MAs in each MD (from low to high levels) and follow the procedure
described in
Figure
7 to create or not to create MIPs (within the same VLAN):
Figure 7 Procedure of creating MIPs
You can choose appropriate MIP generation rules based on your network design.
Follow these steps to configure the rules for generating MIPs: