H3C Technologies H3C S10500 Series Switches - Manual (Page 68)

59
RRPP configuration task list
You can create RRPP domains based on service planning, specify control VLANs and data VLANs for
each RRPP domain, and then determine the ring roles and node roles based on the traffic paths in each
RRPP domain.
Complete the following tasks to configure RRPP:
Task Remarks
Creating an RRPP domain
Required
Perform this task on all nodes in the RRPP domain.
Configuring control VLANs
Required
Perform this task on all nodes in the RRPP domain.
Configuring protected VLANs
Required
Perform this task on all nodes in the RRPP domain.
Configuring RRPP ports
Required
Perform this task on all nodes in the RRPP domain.
Configuring RRPP
rings
Configuring RRPP nodes
Required
Perform this task on all nodes in the RRPP domain
Activating an RRPP domain
Required
Perform this task on all nodes in the RRPP domain.
Configuring RRPP timers
Optional
Perform this task on the master node in the RRPP domain.
Enabling fast detection
Optional
Perform this task on the master node, edge node, and
assistant-edge node in the RRPP domain.
Configuring RRPP
fast detection
Configuring fast detection
timers
Optional
Perform this task on the master node in the RRPP domain.
Configuring an RRPP ring group
Optional
Perform this task on the edge node and assistant-edge node
in the RRPP domain.
NOTE:
•
RRPP does not have an auto election mechanism, so you must configure each node in the ring network
properly for RRPP to monitor and protect the ring network.
• Before configuring RRPP, you must construct a ring-shaped Ethernet topology physically.
Creating an RRPP domain
When creating an RRPP domain, specify a domain ID, which uniquely identifies an RRPP domain. All
devices in the same RRPP domain must be configured with the same domain ID.
Perform this configuration on devices you want to configure as nodes in the RRPP domain.
Follow these steps to create an RRPP domain: