Delta Electronics Extension Digital I/O Module DOP-EXIO14RAE - Manual (Page 42)

Chapter 3 Creating and Editing Programs|DOP-EXIO Series
Revision March, 2008, Doc. Name: 2007PDD23000014 3-21
Besides, as the boxes next to “Copy Comments to Replace Devices” and “Delete
Source Device Comments” are checked both, it indicates that when the device name is
replaced, the comments of the search device “M0 ~ M35” will be copied to the replace
device “Y0 ~ Y43” and the comments of the search device “M0 ~ M35” will be deleted
immediately at the same time.
„ Go to the Start(T) Ö Jump to the start of the program.
Method 1: Click “Search(S)” > ”Go to the Start(T)”.
Method 2: Use keyboard shortcuts by pressing keys (Ctrl) + (Home).
„ Go to the End(N) Ö Jump to the end of the program.
Method 1: Click “Search(S)” > ”Go to the End(N)”.
Method 2: Use keyboard shortcuts by pressing keys (Ctrl) + (End).
3.4 Editng Instructions
„ Input DOP-EXIO Series Instructions
After entering the instruction mode, the user may type an instruction directly. If the
instruction format is valid, press the Enter key on the keyboard to complete the settings.
The input instructions will be located in the editing area and the program memory
address of DOP-EXIO series will appear on the left-hand side of the program. Thus, the
user can get the corresponding program memory addresses of the instructions clearly.
For the introductions of the formats of all instructions, please refer to Appendix A and
Appendix B in this manual.
3.5 Editing Comments
In the ladder diagram mode, there are three operating modes for editing comments: Device
comments, Segment comments and Row comments. Please refer to the following sections for
more introductions on editing comments.
Ladder Diagram Mode: