Delta Electronics Extension Digital I/O Module DOP-EXIO14RAE - Manual (Page 40)

Chapter 3 Creating and Editing Programs|DOP-EXIO Series
Revision March, 2008, Doc. Name: 2007PDD23000014 3-19
Original
Command
Criteria
Replaced
Command
LD X0~X7
LD X10~X11 Type LD + Device X0 → Type LD + Device M100
Device Number: 10
LD M100~M107
LD M108~M109
If the user choose the device type as None, Out and Fun these three types, only the
same type of the device which the name match the replace criteria can be replaced.
When None, Out and Fun these three types are selected, if the user tries to replace the
different type of the device, a warning message dialog box looks like the figure below
will appear.
Besides, the user can use “Copy Comments to Replace Devices” this option to copy the
comments into the replace device. If “Delete Source Device Comments” this option is
also selected, the comments of the search device will be deleted after the comments of
the search device has been copied to the replace device. In this case, the boxes next to
“Copy Comments to Replace Devices” and “Delete Source Device Comments” are
checked both. It indicates that when the device name is replaced, i.e. the “Replace”
button is pressed, the comment of the search device “X0” will be copied to the replace
device “M100” and the comment of the search device “X0” will be deleted immediately
at the same time.
Limits
In “Replace Device” dialog box, only the devices of the same type can be replaced. For
example, if D1 is replaced by D11, it is thus viewed as successful replacement; but if it