Rena MACH X (Digital Color Label Printer) - Manual (Page 44)

SECTION 2
INSTALLING THE PRINTER
38
2
Connecting the Unwinder and Winder to the Printer
Connecting the Unwinder to the Printer:
1. Turn off the printer.
2. Connect the Unwinder’s Interconnect Cord into the 7-pin connector
port [1], located on the non-operator side of the Printer, just below the
USB port.
Connecting the Winder to the Printer:
1. Turn off the Printer.
2. Connect the Winder’s Interconnect Cord into the 7-pin connector
port [2], located on the non-operator side of the Printer, near exit end.
WARNING!
HAZARDOUS MOVING PARTS!
KEEP FINGERS AND OTHER BODY PARTS AWAY!
CAUTION
MAKE SURE THAT THE PRINTER IS TURNED OFF BEFORE
CONNECTING/DISCONNECTING THE UNWINDER AND WINDER.