Rena MACH X (Digital Color Label Printer) - Manual (Page 42)

SECTION 2
INSTALLING THE PRINTER
36
Attaching/Aligning the Unwinder and Winder
Unwinder
The Unwinder is used for “Roll to Cut” and “Roll to Roll” applications.
Proper alignment of the Unwinder and Printer is critical to operation of the Printer. Position the Printer on a
sturdy, stable level work surface with enough room to place the Unwinder at the entry end of the Printer.
Position the Unwinder:
1. Fit square notch cut into the base of the Unwinder
[A] over the pin located along the base of the feed
end of the Printer [B].
2. Make sure base of Unwinder and base of Printer
are flush [C] against each-other.