Rena MACH X (Digital Color Label Printer) - Manual (Page 13)

SECTION 1
GETTING ACQUAINTED
7
Default Printing Modes
The Printer has three default Printing Modes “Roll to Roll”, “Roll to Cut”, and “Fanfold”.
The PRINTING MODE is determined by the current condition/connection of the Unwinder and Winder.
The Winder condition/connection also determines if the automatic function of the Cutter will be disabled or
enabled. See chart below.
NOTE: These defaults will override any presets built into the job being run. Before starting to print a
job make sure the Printer, Unwinder and Winder are set up correctly for that particular job.
PRINTING MODE UNWINDER WINDER CUTTER
Roll to Roll
Connected to
Printer
Powered ON and
Connected to
Printer
Disabled. (Still cuts manually by
pressing 'CANCEL' button.)
Roll to Cut
Connected to
Printer
Powered OFF or
Disconnected from
Printer
Enabled for automatic cutting
Fanfold
Disconnected
from Printer
Powered OFF or
Disconnected from
Printer
Enabled for automatic cutting
See Section 2 “Installing the Printer”, “Loading Labels/Media” for how to load Media.
CAUTION
MAKE SURE THAT THE PRINTER IS TURNED OFF
BEFORE CONNECTING THE UNWINDER AND WINDER.