Rena MACH X (Digital Color Label Printer) - Manual (Page 11)

SECTION 1
GETTING ACQUAINTED
5
Unwinder
1. Speed Control – Turn clockwise to speed up, counterclockwise to slow down.
2. AUTO/Manual Mode Switch – Use to set the Unwinder in Automatic or Manual Mode.
3. Fuse – Unwinder fuse is located here.
4. Hub Assembly – Holds the core. Reversible to fit 1-1/2" and 3" cores.
5. Spindle Lock – Holds the label/media roll in place on the Spindle.
6. Label Roll Spindle – Used to unwind the Media.
7.
Label Tension Arm – Position of weighted shaft controls stopping/starting and rotation
direction of Unwinder; as tension is maintained or released by media web.
8.
24V, 2.5A External Power Connector* – Only needed when using Unwinder with some other
non-interfaced device. External Power is not needed when Unwinder is used with Mach X.
NOTE: External power supply must be a UL Listed power supply.
*Requires internal modification to Unwinder.
9. Unwinder Interconnect Cord – Connects Feeder/Unwinder to Printer.
10.
Alignment Notch – Fits over Alignment Screw on Printer to keep Printer and Unwinder
aligned.